Chrysler 1998 Voyager Service Manual page 1746

23 - 16 BODY
REMOVAL AND INSTALLATION (Continued)
CHILD RESTRAINT SEAT MODULE
Fig. 19 Bucket Seat Track Rear Cover – Power
REMOVAL
(1) Close child restraint seat.
(2) Remove seat back cover.
(3) Remove screws holding child restraint seat
module hinges to seat back frame lower rail (Fig. 20).
(4) Return seat back to upright position.
(5) Disengage push-in fasteners holding upper bol-
ster to child restraint seat module (Fig. 21).
(6) Remove screws holding top of module to seat
back frame upper rail (Fig. 22).
(7) Remove child restraint seat module from seat
back (Fig. 23).
INSTALLATION
(1) Place child restraint seat module in position on
seat back (Fig. 23).
(2) Position seat back hinge interlock lever over
the top of the outboard child restraint seat hinge
(Fig. 24).
(3) Install screws to hold child restraint seat mod-
ule hinges to seat back frame lower rail (Fig. 20).
(4) Install screws to hold top of module to seat
back frame upper rail (Fig. 22).
(5) Install push-in fasteners to hold upper bolster
to child restraint seat module (Fig. 21).
(6) Return seat back to folded position.
(7) Install seat back cover.
(8) Verify child restraint seat operation.
HEAD RESTRAINT – BENCH SEAT
REMOVAL
(1) Lift head restraint to top of travel.
(2) Remove escutcheon from head restraint sleeve.
Fig. 20 Child Restraint Seat Lower Hinge
Fig. 21 Child Restraint Seat Upper Bolster
Fig. 22 Child Restraint Seat Upper Screws
(3) Using a small screw driver, depress retainer
inward to release head restraint (Fig. 25).
(4) Pull head restraint from top of seat back (Fig.
26).
NS