Chrysler 1998 Voyager Service Manual page 1128

9 - 78 3.0L ENGINE
REMOVAL AND INSTALLATION (Continued)
PISTON AND CONNECTING ROD
(1) Identify and mark pistons. The pistons are
not interchangeable from bank to bank (Fig. 45).
(2) Pistons with the letter R and arrow toward the
front of engine are to be installed in cylinders 1-3-5.
Pistons with the letter L and arrow toward the front
of engine are to be installed in cylinders 2-4-6.
(3) Mark connecting rod and cap with cylinder
number (Fig. 46).
(4) Remove piston rings (Fig. 47).
Fig. 45 Mark Pistons
FITTING PISTONS
Measure approximately 2 mm (0.080 in.) above the
bottom of the piston skirt and across the thrust face
(Fig. 48). See Boring Cylinder in Cylinder Block.
Fig. 44 Pistons and Connecting Rods
Fig. 46 Mark Matching Parts
Fig. 47 Remove Piston Rings
NS