Chrysler 1998 Voyager Service Manual page 1267

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 6 Throttle Body Electrical Connectors
(6) Remove vacuum lines for purge solenoid and
PCV valve at intake manifold (Fig. 7).
(7) Remove vacuum lines for power brake booster
and speed control vacuum reservoir at upper intake
manifold fittings (Fig. 8).
(8) Remove throttle cable and speed control cable
(if equipped) from throttle lever (Fig. 9).
(9) Remove throttle cables from bracket by com-
pressing retaining tabs.
Fig. 7 Vacuum Line Connections
(10) Remove two top bolts from intake manifold to
rear support bracket and spacer (Fig. 10).
(11) Remove upper bolt from intake manifold to
front support bracket (Fig. 11).
(12) Remove dipstick.
(13) Remove dipstick tube.
CAUTION: Moving the dipstick tube will cause dam-
age to the sealer, causing an oil leak. Dipstick tube
must be sealed at cylinder block.
(14) Remove upper intake manifold bolts. Remove
upper intake manifold.
EXHAUST SYSTEM AND INTAKE MANIFOLD
Fig. 8 Vacuum Fitting at Rear of Upper Intake
Fig. 9 Throttle Cable Attachment to Throttle Body
CAUTION: Cover intake manifold to prevent foreign
material from entering engine.
Fig. 10 Intake Manifold Rear Support Bracket
Manifold
11 - 5