Chrysler 1998 Voyager Service Manual page 1778

23 - 48 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 58 Liftgate Latch Striker
INSTALLATION
(1) Place striker in position on vehicle.
(2) Align striker to outline mark on sill.
(3) Install screws to attach striker to sill.
(4) Verify liftgate alignment and operation.
LIFTGATE LOCK CYLINDER
REMOVAL
NOTE: Do not remove E-clip.
(1) Remove outside liftgate handle.
(2) Remove lock cylinder clip from handle (Fig. 59).
(3) Remove lock cylinder and arm from handle.
INSTALLATION
(1) Install lock cylinder clip into liftgate handle.
(2) Push lock cylinder into handle until clip
engages groove in lock cylinder with an audible click
(Fig. 60).
(3) Install outside liftgate handle.
(4) Verify lock cylinder operation.
LIFTGATE OUTSIDE HANDLE
REMOVAL
(1) Remove liftgate trim panel.
(2) Remove power lock motor.
(3) Disengage outside handle link from clip on lift-
gate latch.
(4) Disconnect VTSS switch from back of lock cyl-
inder, if equipped.
(5) Disengage lock link, if equipped.
(6) Remove nut attaching outside liftgate handle to
liftgate (Fig. 61).
(7) Disengage retaining groove holding handle to
liftgate.
(8) Remove outside liftgate handle and links from
vehicle.
Fig. 59 Lock Cylinder Removal
Fig. 60 Lock Cylinder Installation
INSTALLATION
(1) Position outside liftgate handle and links on
vehicle.
(2) Engage retaining groove to hold handle to lift-
gate by pushing handle to the right for centering.
(3) Install nut to attach outside liftgate handle to
liftgate.
NS