Chrysler 1998 Voyager Service Manual page 1314

14 - 20 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
(3) Remove air inlet resonator (Fig. 36).
Fig. 36 Air Inlet Resonator
(4) Remove throttle cable (Fig. 37).
Fig. 37 Throttle Cable Attachment
(5) Disconnect electrical connectors from the idle
air control motor and Throttle Position Sensor (TPS).
(6) Remove vacuum hose harness from throttle
body (Fig. 38).
(7) Remove electrical connector from the coolant
temperature sensor (Fig. 39).
(8) Remove vacuum connections from air intake
plenum vacuum connector (Fig. 39).
(9) Remove the fuel hose quick connect fitting from
the chassis tube (Fig. 40). Refer to Fuel Hoses,
Clamps and Quick Connect Fittings in this Sec-
tion. Place a shop towel under the connections to
absorb any fuel spilled from the fitting.
Fig. 38 Electrical and Vacuum Connection to
Throttle Body
Fig. 39 Coolant Temperature Sensor Electrical
Connections
WARNING: WRAP A SHOP TOWEL AROUND
HOSES TO CATCH ANY GASOLINE SPILLAGE.
Fig. 40 Fuel Line Quick Disconnect
NS