Chrysler 1998 Voyager Service Manual page 1804

23 - 74 BODY
REMOVAL AND INSTALLATION (Continued)
SLIDING DOOR STABILIZER SOCKET
REMOVAL
(1) Open sliding door.
(2) Remove screws holding stabilizer socket to
B-pillar (Fig. 123).
(3) Remove stabilizer socket from vehicle.
Fig. 123 Sliding Door Stabilizer Socket
INSTALLATION
(1) Place stabilizer socket in position on vehicle.
(2) Install screws to hold stabilizer socket to B-pillar.
(3) Close sliding door and verify operation.
SLIDING DOOR STOP BUMPER
REMOVAL
(1) Remove center stop bumper trim panel.
(2) Loosen screws holding rear of stop bumper to
door inner panel (Fig. 124).
(3) Remove screw holding front of stop bumper to
door inner panel.
(4) Remove stop bumper from vehicle.
INSTALLATION
(1) Place stop bumper in position on vehicle.
(2) Install screw to hold front of stop bumper to
door inner panel (Fig. 124).
(3) Tighten screws to hold rear of stop bumper to
door inner panel.
(4) Install trim panel.
SLIDING DOOR TRIM PANEL
REMOVAL
(1) Remove sliding door upper frame molding.
(2) If removing the left sliding door trim panel,
remove screw from inside ash receiver bezel.
(3) Remove screws holding trim panel to inner
door panel (Fig. 126).
Fig. 124 Sliding Door Stop Bumper
(4) Disengage push-in fasteners holding trim to
door panel around perimeter and upper edge of door
(Fig. 125).
(5) Remove sliding door trim panel from vehicle.
Fig. 125 Sliding Door Trim Panel
INSTALLATION
(1) Place sliding door trim panel in position on
vehicle.
(2) Align locating pins on backside of trim panel to
mating holes in the inner door panel.
(3) Engage push-in fasteners to hold trim to door
panel around perimeter and upper edge of door (Fig.
125).
(4) Install screws to hold trim panel to inner door
panel.
NS