Chrysler 1998 Voyager Service Manual page 1802

23 - 72 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 116 Sliding Door Lower Roller Arm
Fig. 117 Sliding Door Roller Arm Channel
Fig. 118 Sliding Door Lower Roller Arm Bracket
INSTALLATION
(1) Place lower roller bracket in position on vehi-
cle.
(2) Align outline mark on inside of sliding door to
roller arm bracket.
(3) Install bolts holding lower roller arm bracket to
sliding door.
(4) Install lower roller arm.
(5) Remove lifting device.
(6) Verify sliding door operation.
(7) Install access hole plug.
SLIDING DOOR OUTSIDE LATCH RELEASE HANDLE
REMOVAL
(1) Remove sliding door trim panel.
(2) Remove sliding door stop bumper.
(3) Remove watershield as necessary to access out-
side release handle fasteners.
(4) Remove latch/lock control cover.
(5) Disengage clip holding outside door handle
linkage to door handle.
(6) Separate linkage from outside door handle.
(7) Separate linkage from latch/lock control.
(8) Remove nuts holding outside door handle to
outer door panel (Fig. 119).
(9) Remove outside door handle from vehicle.
Fig. 119 Sliding Door Outside Latch Release Handle
INSTALLATION
(1) Position outside door handle on vehicle.
(2) Install nuts to hold outside door handle to
outer door panel.
(3) Insert linkage into outside door handle.
(4) Engage clip to hold linkage to outside door
handle.
(5) Engage rigging cam to latch/lock control mech-
anism.
(6) Move clip on latch/lock control to bottom of slot
and engage linkage to latch/lock control.
(7) Verify sliding door operation. Adjust as neces-
sary.
(8) Install latch/lock cover.
(9) Install watershield.
(10) Install sliding door stop bumper.
(11) Install sliding door trim panel.
NS