Install Servo Motor - ENCAD NovaJet Pro 600e Service Manual

14. Lower the motor to clear the pulley assembly from the platen and
carefully bring the motor out of the printer.

Install Servo Motor

1. Reinsert the Servo Motor under the Platen with the connector
facing the FRONT side of the Platen. Guide the pulley up
through the opening in the Platen.
2. Once the Servo Motor pulley is through the Platen, push up on
the Servo Motor and align the screw holes with the screw hole
openings.
3. Insert the front screw into the Servo Motor and tighten it almost
all the way.
4. Lift up gently and hold the right end of the Trailing Cable.
5. Insert the back screw into the Servo Motor and tighten it.
6. Tighten both screws on the Servo Motor to 15 in-lb of torque.
7. Depress the back of the Frame Tensioner and wrap the Carriage
Belt over the Servo Motor pulley. Make sure that the guides on
the inside of the belt are inserted in the pulley grooves and that
the belt is not twisted.
8. Move the Carriage Assembly back and forth to check the Carriage
Belt tension.
9. Reinstall the Right Sideplate with four screws and a #2 Phillips
screwdriver. Press the side plate down and towards the back of
the printer before tightening. Torque to 15 in-lb.
Make sure the screw does not go into the motor at an
angle, and be careful not to strip the head of the screw
or to cause damage to the Encoder Strip.
NovaJet PRO 600e Service Manual
Assembly\Disassembly 5-19