ENCAD NovaJet Pro 600e Service Manual page 141

NovaJet PRO 600e Service Manual
2. Route the Load Sensor wires through the four wire clamps on the
back part of the Y-Arm Bracket.
3. Install the Slide Shaft and two supports to the Y-Arm Assembly
using four screws. Torque to 8 in-lbs.
4. Insert the back compression spring onto the shaft of the pinch roller
and push the back of the shaft through the back of the Y-Arm
Assembly. Install the C clamp around the shaft of the pinch roller.
5. While compressing the forward pinch roller spring with a
screwdriver (or other flat object), position the pinch roller onto the
Y-Arm Assembly until the forward spring is located under the hole
in the Slide Shaft. Release the spring and verify that the spring
enters the hole in the Slide Shaft and that no kinks are present in
the spring.
6. Perform steps 4 and 5 for all pinch rollers.
7. Using a #2 Phillips screwdriver, secure the Y-Arm Assembly to the
Platen using seven screws. Torque to 15 in-lbs.
8. Perform the Install the Stabilizer Bracket and Encoder Strip
procedures to install the Stabilizer Bracket and Encoder Strip.
9. Perform the Install the Carriage Assembly, Carriage Belt, and the
Frame Tensioner Procedures to install the Carriage Assembly,
Carriage Belt, and the Frame Tensioner.
10. Perform the Install the Trailing Cable Assembly procedures to
install the Trailing Cable Assembly.
11. Perform the Install the Ink Delivery System procedures to install
the Ink Delivery System.
12. Perform the Install the Left, Top, and Right Covers procedures to
install the Left, Top and Right Covers.
13. Perform the Head Height Adjustment procedures found in Chapter
3 of this service manual.
5-42 Assembly\Disassembly