Install The Y-Arm Assembly, Pinch Rollers, Slide Shaft, And Auto-Load Sensor - ENCAD NovaJet Pro 600e Service Manual

9. Spin the back of the pinch roller to either side and remove the
back spring.
10. Carefully tilt the back of the pinch roller upwards. This brings
the front of the pinch roller down, away from the Slide Shaft.
Carefully remove the spring that is going into the Slide Shaft
from the top of the pinch roller.
11. Remove the pinch roller.
12. From the bottom of the Y-Arm Assembly, remove the four screws
that secure the Slide Shaft and its two supports from the Y-Arm
Assembly.
13. Using a #1 Phillips screwdriver, remove the two screws that
secure the Auto-Load Sensor to the Y-Arm. Remove the Auto-
Load Sensor wires from the four wire clamps on the back part of
the Y-Arm Bracket.
Install the Y-Arm Assembly, Pinch Rollers, Slide
Shaft, and Auto-Load Sensor
1. Install the Auto-Load Sensor Assembly into the back part of the
Y-Arm Bracket using a #1 Phillips screwdriver. Torque to 6 in-
lbs.
NovaJet PRO 600e Service Manual
Figure 5-23. Pinch Roller.
Assembly\Disassembly 5-41