ENCAD NovaJet Pro 600e Service Manual page 103

NovaJet PRO 600e Service Manual
8. Disconnect the Display data ribbon cable connector at the J12
location on the MPCB.
9. Disconnect the Display Power Converter connector at the J10
location on the MPCB. To disconnect, grasp the Display Power
Converter connector between thumb and forefinger and pull straight
out.
To remove the Left Cover Assembly:
10. Open the reservoir access Door. Disconnect and remove all ink
reservoirs.
Figure 5-2. Left Cover Assembly Removal/Installation.
11. With a #2 Phillips screwdriver, remove the two screws securing the
Left Cover Assembly to the Left Baseplate and the two screws
securing it to the Left Sideplate. See Figure 5-2.
12. Reach under the Support Bracket and depress and hold the
retracting stop assembly that secures the Left Cover Assembly to
the Support Bracket.
13. Carefully lift the Left Cover Assembly up and off the printer.
5-4 Assembly\Disassembly