ENCAD NovaJet Pro 600e Service Manual page 147

NovaJet PRO 600e Service Manual
6. Reaching inside the Fan Exhaust hole under the Platen, position
and secure the Fan Assembly(ies) using a #2 Phillips screwdriver.
7. Reinstall the Fan Exhaust Assembly(ies) using a #2 Phillips
screwdriver.
8. Install the Lower Drive Roller Assembly support brackets using a
#2 Phillips screwdriver.
9. Reinsert the Foam Block. Make sure that the Stepper Motor and
Fan(s) cables are exiting out of the back corner of the Foam Block.
See Figure 5-26. The Foam Block is positioned between the Stepper
Motor and the Servo Motor. Make sure it is not tilted at an angle.
5-48 Assembly\Disassembly
Figure 5-26. Inside Platen, Right Side.