Head Height Alignment Procedure - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual
Figure 3-13. Slide Shaft Profile Adjustment.
For example: If the Left = 0, Right = +0.004", then the center should

Head Height Alignment Procedure

Perform this procedure only when the encoder strip stabilizer has been
removed from the Y-Arm or whenever the alignment is in question.
The head height alignment procedure is to ensure that a 0.065" +/-
0.003" difference exists between the cartridge jet plate and the Platen.
See Figure 3-14.
3-20 Maintenance
be adjusted to + 0.002". This will ensure a smooth plane of
travel for the carriage assembly. There are no adjustments
on either end of the shaft in all models.