Install Extra Memory (Simm); Remove The Mpcb (Main Printed Circuit Board) - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual

Install Extra Memory (SIMM)

1. The SIMM slots are at a 90° angle from the board. Place the SIMM
at a 45° into the connector as shown in Figure 5-5.
2. Slowly push the SIMM up to a 90° angle until the two side clips
snap into place. Make sure the SIMM is fully seated.
3. Perform steps 4 through 10 of the Install the Left, Top, and Right
Covers procedure to install the Right and Top Covers.

Remove the MPCB (Main Printed Circuit Board)

1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
2. Put on an ESD wrist strap.
3. Perform step 2 of the Remove Extra Memory (SIMM) procedure to
remove any memory that was added.
4. Disconnect the Power Supply connection at the J15 location by
grasping the Power Supply connector with thumb and forefinger
and pulling straight out. See Figure 3-4 for jack locations.
5-10 Assembly\Disassembly
If you are installing two SIMM, you must install the one
located in J17 first. See Figure 3-4 for location.
Integrated circuits may become weakened or damaged by
electrical discharge. Do not touch or work near integrated
circuits without wearing an ESD wrist strap.
NOTE