Remove Power Supply, Cooling Fan, And Ac Entry Module - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual
13. Connect the Power Supply connector to J15 on the MPCB.
14. Reinstall any additional memory into J17 by performing steps 1 and
2 of the Install Extra Memory (SIMM) procedure.
15. Perform steps 4 through 10 of the Install the Left, Top, and Right
Covers procedure to install the Right and Top Covers.
Remove Power Supply, Cooling Fan, and AC Entry
Module
1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
2. Perform steps 3 through 15 of the Remove the MPCB (Main Printed
Circuit Board) procedure to remove and protect the MPCB.
3. Reach between the Power Supply Bracket and the AC Entry Module
and carefully pull out the quick disconnect assembly attaching the
Power Supply input to the AC Entry Module. Disconnect the Power
Supply input from the AC Entry Module.
4. Disconnect the clip securing the power supply wires to the top of the
support bracket.
5. While holding the Power Supply in place, remove the four screws
securing it to the Power Supply Bracket. See Figure 5-7.
6. Slide the Power Supply out of the Power Supply Bracket.
5-14 Assembly\Disassembly