ENCAD NovaJet Pro 600e Service Manual page 139

NovaJet PRO 600e Service Manual
4. Perform steps 3 and 4 of the Remove the Trailing Cable Assembly
procedures to remove the Trailing Cable Assembly.
5. Perform steps 5 and 6 of the Remove the Stabilizer Bracket and
Encoder Strip procedures to remove the Stabilizer Bracket
Assembly.
6. Disconnect the Load Sensor connector at the J4 location on the
MPCB. Grasp the Load Sensor connector with the thumb and
forefinger and pull straight out.
7. Remove the seven screws that secures the Y-Arm Assembly to the
Platen. See Figure 5-22.
8. The pinch rollers are held on by a small C clamp located on the
back of the Y-Arm Assembly. See Figure 5-23. While holding the
pinch roller, remove the C clamp and move the pinch roller towards
the front of the Y-Arm Assembly until it clears the back of the Y-
Arm Bracket.
5-40 Assembly\Disassembly
Figure 5-22. Y-Arm Installation/Removal.