ENCAD NovaJet Pro 600e Service Manual page 102

To remove the Right Cover Assembly:
Figure 5-1. Right Cover Assembly Removal/Installation.
4. With a #2 Phillips screwdriver, remove the three screws securing
the Right Cover Assembly to the Right Baseplate and the two
screws securing it to the Right Sideplate. See Figure 5-1.
5. Reach under the Support Bracket and depress and hold the
retracting stop assembly that secures the Right Cover Assembly to
the Support Bracket.
6. Carefully lift up on the Right Cover Assembly until it clears the
printer enough to gain access to the Keypad, Display, and
Backlight connections going to the Main Printed Circuit Board
(MPCB).
7. Disconnect the Keypad flex cable connection at the J13 location on
the MPCB. See Figure 3-4 for jack locations on the MPCB.
NovaJet PRO 600e Service Manual
Assembly\Disassembly 5-3