Remove The Trailing Cable Assembly; Install The Trailing Cable Assembly - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual

Remove the Trailing Cable Assembly

1. Perform steps 1 through 13 of the Remove the Left, Top, and Right
Covers procedures to remove the Left, Top and Right Covers.
2. If you have not already removed the Carriage Assembly from the
Slide Shaft, you will need to perform Steps 3 through 7 of the
Removing the Carriage Assembly, Carriage Belt, and the Frame
Tensioner procedures in order to remove the Electronics Cover and
release the left end of the Trailing Cable from the Carriage PCB.
3. Disconnect the Trailing Cable Assembly connector at the J6 location
on the MPCB. Use the thumb and forefinger to pull forward on the
connector lock and remove the Trailing Cable from the connector.
See Figure 3-6 if necessary.
4. The Trailing Cable Assembly is secured to the Stabilizer Bracket by
two pieces of double sided tape. Remove the Trailing Cable
Assembly from the Stabilizer Bracket.
5. Remove the ferrite and the tape securing it to the Trailing Cable.

Install the Trailing Cable Assembly

1. Apply two new pieces of double sided tape to the Stabilizer Bracket.
Ensure that the tape is in the same location as the original tape
was.
2. Slip the ferrite around the Trailing Cable and insert the right side
of the Trailing Cable Assembly through the access hole provided in
the Right Side plate.
5-36 Assembly\Disassembly
The right side of the Trailing Cable (the side connected to
the MPCB) must extend beyond the Stabilizer Bracket by
5" (4 7/8" - 5 1/8") or 128mm (125mm - 131mm.)