Power Feed And Take-Up Motor Winding Resistance Check - ENCAD NovaJet Pro 600e Service Manual

Power Feed and Take-Up Motor Winding
Resistance Check
1. Remove the feed and/or take-up roll from the printer.
2. Using Phillips screwdriver, remove the four screws that
3. Ease the cradle idler off of the leg enough to disconnect the
4. Using a standard ohmmeter or multimeter, measure between
5. If the measurement is found to be unsatisfactory, replace the
6. Perform the same procedure on the remaining motor.
Figure 3-9. Power Feed and Take-Up Motor.
secure the cradle idler from the right leg.
motor wires from the leg harness.
the + and - connections on the motor. While manually
rotating the servo motor, monitor the readings on the meter.
The acceptable range is 25-40 ohms. Typically, the reading is
29-36 ohms.
motor.
NovaJet PRO 600e Service Manual
Maintenance 3-13