ENCAD NovaJet Pro 600e Service Manual page 59

NovaJet PRO 600e Service Manual
dure is to ensure that the Slide Shaft is relatively perpendicular to the
surface of the Platen and to remove any bowing that may be present in
the shaft's profile.
You will need the following:
·
·
There are two basic measurements that are to be made using
this kit (ensure power is off prior to performing these procedures):
1. Connect the dial gauge micrometer to the Shaft mounting
3-18 Maintenance
Height Gauge Kit Assembly
1/4" open and box end wrench (.110" thick)
Height Gauge (Alignment) Kit Contents are:
Dial Gauge Micrometer
Modified Novajet PROe/PRO 600e/1500 TX Cartridge
Modified Novajet 4/Pro/Pro 50 Cartridge - Not Used
Platen/Carriage Shaft Mounting Block
Calibration Jo Block (1.434")
Plastic Gauge Card (0.011")
1. Slide Shaft Profile Adjustment
2. Carriage (Cartridge) Head Height Setting
block as shown in Figure 3-11.
Figure 3-11. Dial Gauge Micrometer Assembly.
- Not used
- Not used