Table of Contents
Advertisement
7. After hearing the single beep, remove power from printer for 15-
8. If the firmware download is not successful you may hear more
Firmware Download/Upgrading for the MAC
The normal method of downloading new firmware is to send the file as if
it was a standard print job.
1. Power OFF printer, wait 15 seconds.
2. Connect an Image Writer II cable between the printer and
3. Turn the printer ON.
4. Obtain the latest firmware revision from the ENCAD web site,
20 seconds. Apply power to the printer. The printer should
initialize properly. Verify firmware revision by sequencing
through Utility Menu - Service Menu - About menu.
Verify firmware has been incorporated.
than 1 beep or complete silence. Check parallel port connections
and return to step 5.
MAC.
unpack the file and launch the "600E Firmware Utility." File
names may be different then that listed above.
Click on "File"
Click on "Preferences"
Select the appropriate port that the NJ PRO 600e printer is
connected to (either Modem or Printer.)
Drag and Drop the 600E.ROM file (or the latest version) into
the "Spool Folder".
Wait approximately 20 to 40 seconds later until you hear a
SINGLE beep, indicating the download was successful. You may
encounter a set of double beeps shortly after sending the
firmware file, but you must wait until you hear the SINGLE
beep.
NovaJet PRO 600e Service Manual
Maintenance
3-37
Advertisement
Table of Contents
Troubleshooting
