ENCAD NovaJet Pro 600e Service Manual page 143

NovaJet PRO 600e Service Manual
6. Using a #2 Phillips screwdriver, remove the two screws that secure
the Left Sideplate Assembly to the Platen. See Figure 5-24.
7. Using a #1 Phillips screwdriver, remove the four screws on the
bottom of the Platen which holds the Fan Exhaust(s) in place.
8. While holding the Vacuum Fan through the hole left when the
Exhaust assembly was removed, remove the 3 screws on the bottom
of the Platen that holds the Vacuum Fan in place using a #2
Phillips screwdriver. Do not allow the screws to come out at an
angle.
5-44 Assembly\Disassembly
The Novajet PRO 600e 42 inch model has one Vacuum
Fan and Exhaust assembly while the 60 inch has two
sets of Vacuum Fans and Exhausts.
Figure 5-24. Inner Platen Assembly/Disassembly.
NOTE