Install The Paper Sensor Or The Encoder Sensor - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual
c.
on the Encoder until the plastic pieces on each side of the Encoder
clear the ridges which hold it in place. Then pull it straight out.
See Figure 5-8.

Install the Paper Sensor or the Encoder Sensor

1. To install the Paper Sensor:
a. Turn the Carriage Assembly so that the bottom side of it is
facing up.
b. Route the flex on the Paper Sensor through the slot in the
Carriage Assembly. Make sure the flex cable goes all the way
through and does not curl under the Carriage PCB.
c.
guide the sides of the board into the grooves on each side of the
opening. See Figure 5-17.
d. Push the Paper Sensor board down into the Carriage Assembly
until it snaps firmly into place.
5-32 Assembly\Disassembly
Push down on the plastic clip and at the same time push down
Figure 5-17. Paper and Encoder Sensor Installation.
Grasp the Paper Sensor between thumb and index finger and