Install The Carriage Pcb; Remove The Paper Sensor Or The Encoder Sensor - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual
6. Place the Carriage PCB in an ESD bag (antistatic bag) in
preparation for shipment to ENCAD for replacement or repair, or if
it is to be stored at your facility for repair.

Install the Carriage PCB

1. Put the tab on the left end of the Carriage PCB into the slot in the
left side of the Carriage Assembly. See Figure 5-15.
2. Ensure that no flex cables are underneath the Carriage PCB.
3. Push down the right end of the Carriage PCB until the latch snaps
into place.
4. Reattach all flex cables on the Carriage PCB.
5. Perform the Install the Carriage Assembly, Carriage Belt, and the
Frame Tensioner procedures to reinstall the Carriage Assembly.

Remove the Paper Sensor or the Encoder Sensor

1. Perform the Remove the Carriage Assembly, Carriage Belt, and the
Frame Tensioner procedures to remove the Carriage Assembly from
the Slide Shaft.
5-30 Assembly\Disassembly
Failure to use an approved antistatic bag for storage or
shipment may cause damage to the Carriage PCB and
affect the Warranty.