Mazda RX-8 Workshop Manual page 577

< Previous Next >
2011 - RX-8 - Engine
DTC P2007 [13B-MSP]
DTC P2007 APV stuck closed (No.2)
DETECTION
CONDITION
POSSIBLE
CAUSE
The PCM monitors the input voltage from the APV position sensor No.2 when the APV is
opened. If the input voltage is less than 1.0 V, the PCM determines that the APV is
stuck closed.
Diagnostic support note
This is a continuous monitor (CCM).
The MIL illuminates if the PCM detects the above malfunction condition in two
consecutive drive cycles or in one drive cycle while the DTC for the same malfunction
has been stored in the PCM.
PENDING CODE is available if the PCM detects the above malfunction condition during
the first drive cycle.
FREEZE FRAME DATA (Mode 2/Mode 12) is available.
The DTC is stored in the PCM memory.
APV control malfunction
APV motor malfunction
APV position sensor No.2 connector or terminals malfunction
APV position sensor No.2 malfunction
Short to ground in wiring harness between APV position sensor No.2 terminal C and
PCM terminal 2AR
Short to ground in wiring harness between APV position sensor No.2 terminal A and
PCM terminal 2AF
PCM connector or terminals malfunction
PCM malfunction