Mazda RX-8 Workshop Manual page 876

< Previous Next >
2011 - RX-8 - Engine
OIL CONTROL VALVE (OCV) INSPECTION [13B-MSP]
Coil Resistance Inspection
1. Remove the engine cover. (See
2. Remove the battery cover. (See
3. Disconnect the negative battery cable. (See
4. Remove the OCV. (See
5. Measure the coil resistance between terminals A and B using a tester.
If not within the specification, replace the OCV.
OCV standard resistance
6.9—7.9 ohms [20°C {68°F}]
6. Install the OCV. (See
7. Connect the negative battery cable. (See
8. Install the battery cover. (See
9. Install the engine cover. (See
Spool Valve Operation Inspection
1. Remove the engine cover. (See
ENGINE COVER REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION
OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
ENGINE COVER REMOVAL/INSTALLATION
ENGINE COVER REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)