Mazda RX-8 Workshop Manual page 213

Is any related repair information
available?
INSPECT BARO SENSOR MALFUNCTION
3
Start the engine.
Access the BARO PID using the
M-MDS.
(See
TEST
Inspect that the BARO PID within
the specification.
(See
MSP].)
Is there any malfunction?
VERIFY TROUBLESHOOTING OF DTC P0107
4
COMPLETED
Make sure to reconnect all
disconnected connectors.
Clear the DTC from the PCM
memory using the M-MDS.
(See
[13B-MSP].)
Perform the KOEO or KOER self
test.
(See
[13B-MSP].)
Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
5
Perform the "AFTER REPAIR
PROCEDURE".
(See
[13B-MSP].)
Are any DTCs present?
< Previous Next >
ON-BOARD DIAGNOSTIC
[13B-MSP].)
PCM INSPECTION [13B-
AFTER REPAIR PROCEDURE
KOEO/KOER SELF TEST
AFTER REPAIR PROCEDURE
© 2011 Mazda North American Operations, U.S.A.
No Go to the next step.
YesReplace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [13B-
MSP].)
No Go to the next step.
YesReplace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [13B-
MSP].)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE
No DTC troubleshooting completed.
[13B-MSP].)
Back to Top