Mazda RX-8 Workshop Manual page 429

VERIFY TROUBLESHOOTING OF DTC P2101 COMPLETED
21
Make sure to reconnect all disconnected connectors.
Clear the DTC from the PCM memory using the M-MDS.
(See AFTER REPAIR PROCEDURE
Start the engine and idle it.
Turn the ignition switch off, then to the ON position (engine
off).
Perform the KOEO or KOER self test.
(See KOEO/KOER SELF TEST
Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
22
Perform the "AFTER REPAIR PROCEDURE".
(See AFTER REPAIR PROCEDURE
Are any DTCs present?
< Previous Next >
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
© 2011 Mazda North American Operations, U.S.A.
Repair or replace if necessary, then go to the
next step.
YesReplace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE [13B-MSP].)
No DTC troubleshooting completed.
[13B-MSP].)
Back to Top