Mazda RX-8 Workshop Manual page 512

VERIFY RELATED REPAIR INFORMATION
3
AVAILABILITY
Verify related Service Bulletins and/or
on-line repair information availability.
Is any related repair information
available?
VERIFY RELATED PENDING CODE OR STORED
4 DTC
Turn the ignition switch off, then to the
ON position (engine off).
Verify the related PENDING CODE or
stored DTCs.
Are other DTCs present?
VERIFY CURRENT INPUT SIGNAL STATUS
5
Access the following PIDs using the M-
MDS:
(See ON-BOARD DIAGNOSTIC TEST
[13B-MSP].)
Are the PIDs normal?
(See PCM INSPECTION
VERIFY CURRENT INPUT SIGNAL STATUS UNDER
6
FREEZE FRAME DATA (MODE 2) CONDITION
CAUTION:
While performing this step with vehicle
driving, always operate the vehicle in a
APP
ECT
MAF
TP REL
VSS
[13B-MSP].)
YesPerform repair or diagnosis according to
the available repair information.
If the vehicle is not
repaired, go to the next
step.
No Go to the next step.
Yes If misfire DTC is present,
go to Step 9.
If other DTC is present,
go to the appropriate
DTC inspection.
(See
DTC TABLE [13B-
MSP].)
No If drive ability concern is
present, go to Step 9.
If other, go to the next
step.
YesGo to the next step.
No Repair or replace the malfunctioning part
according to the inspection results, then
go to Step 24.
YesGo to the next step.
No Repair or replace the malfunctioning part
according to the inspection results, then
go to Step 24.