Mazda RX-8 Workshop Manual page 353

Make sure to reconnect all
disconnected connectors.
Clear the DTC from the PCM
memory using the M-MDS.
(See
PROCEDURE
Start the engine.
Perform the Pending Trouble
Code Access Procedure.
(See
TEST
Is the PENDING CODE same
as DTC present?
VERIFY AFTER REPAIR PROCEDURE
12
Perform the "AFTER REPAIR
PROCEDURE".
(See
PROCEDURE
Are any DTCs present?
< Previous Next >
AFTER REPAIR
[13B-MSP].)
ON-BOARD DIAGNOSTIC
[13B-MSP].)
AFTER REPAIR
[13B-MSP].)
© 2011 Mazda North American Operations, U.S.A.
(See PCM REMOVAL/INSTALLATION
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE
No DTC troubleshooting completed.
[13B-MSP].)
[13B-MSP].)
Back to Top