Mazda RX-8 Workshop Manual page 328

VERIFY RELATED REPAIR INFORMATION
2
AVAILABILITY
Verify related Service Bulletins
and/or on-line repair
information availability.
Is any related repair information
available?
INSPECT INSTRUMENT CLUSTER
3
Perform the "INSTRUMENT
CLUSTER INPUT/OUTPUT
CHECK MODE".
(See INSTRUMENT CLUSTER
INPUT/OUTPUT CHECK
Is there any malfunction?
INSPECT FUEL GAUGE SENDER UNIT
4
(MAIN)
Inspect the fuel gauge sender
unit (main).
(See FUEL GAUGE SENDER
UNIT INSPECTION.)
Is there any malfunction?
VERIFY TROUBLESHOOTING OF DTC
5
P0461 COMPLETED
Make sure to reconnect all
disconnected connectors.
Clear the DTC from the PCM
memory using the M-MDS.
(See AFTER REPAIR
PROCEDURE
Start the engine.
Drive the vehicle under the
FREEZE FRAME DATA (Mode 2)
condition.
Perform the Pending Trouble
Code Access Procedure.
(See ON-BOARD DIAGNOSTIC
TEST [13B-MSP].)
Is the PENDING CODE same as
DTC present?
MODE.)
[13B-MSP].)
YesPerform repair or diagnosis according to the
available repair information.
If the vehicle is not repaired, go
to the next step.
No Go to the next step.
YesRepair or replace the malfunctioning part
according to the inspection results, then go to
Step 5.
No Go to the next step.
YesReplace the fuel gauge sender unit (main), then
go to the next step.
(See FUEL GAUGE SENDER UNIT
REMOVAL/INSTALLATION.)
No Go to the next step.
YesReplace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION
No Go to the next step.
[13B-MSP].)