Mazda RX-8 Workshop Manual page 571

VERIFY RELATED PENDING CODE OR STORED DTCs
3
Turn the ignition switch off, then to the ON position (engine
off).
Verify related pending code or stored DTCs.
Are any other DTCs present?
PRELIMINARY EVAP SYSTEM TEST
4
Perform the EVAP system leak inspection using the M-MDS.
(See ENGINE CONTROL SYSTEM OPERATION INSPECTION
[13B-MSP].)
Verify that all PIDs are within the following specifications:
NOTE:
To successfully perform this procedure, all
PIDs must be within specification before
proceeding to the next step.
Select the following items
from the initialization
screen of the M-MDS.
Select "Powertrain".
Select "Fuel".
Select "EVAP Test".
Verify that ECT and IAT
are within the specification
on the confirmation screen.
To successfully perform
this procedure, ECT and
IAT must be within the
specification before
proceeding to the next
step.
The fuel level must be
maintained within 15%—
85%. The PCM will cancel
If the
vehicle
is not
repaired,
go to
the next
step.
No Go to the next step.
YesGo to the appropriate
DTC troubleshooting.
(See DTC TABLE [13B-
MSP].)
No Go to the next step.
YesGo to the appropriate
DTC troubleshooting.
(See DTC TABLE [13B-
MSP].)
No Go to the next step.