Mazda RX-8 Workshop Manual page 844

1 Universal joint
(See STEERING GEAR AND LINKAGE
(See EPS SYSTEM NEUTRAL POSITION
2 Oil hose
(See Oil Hose Removal Note.)
(See Oil Hose Installation
3 Oil pipe, oil hose (AT)
(See OIL COOLER REMOVAL/INSTALLATION
4 Caliper and mounting support
5 Shock absorber bolt (lower)
6 Front tunnel member
7 Rear tunnel member
8 Catalytic converter, middle pipe, main silencer
(See EXHAUST SYSTEM REMOVAL/INSTALLATION
9 Heat insulator
10Power plant frame
(See Power Plant Frame, Crossmember Bolt Removal/Installation
(See TRANSMISSION REMOVAL/INSTALLATION
(See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION
11Propeller shaft
(See PROPELLER SHAFT REMOVAL/INSTALLATION.)
12Under cover
13Transverse member
14Engine, transmission, crossmember component
(See Power Plant Frame, Crossmember Bolt Removal/Installation
17. Remove the engine and transmission from the crossmember component lifter in the order indicated in the table by suspending them
with a crane.
REMOVAL/INSTALLATION.)
SETTING.)
Note.)
[SJ6A-EL].)
[13B-MSP].)
[P66M-D].)
Note.)
[SJ6A-EL].)
Note)