Mazda RX-8 Workshop Manual page 185

2011 - rx-8
Hide thumbs Also See for RX-8:
Table of Contents

Advertisement

corrosion).
Is there any malfunction?
VERIFY TROUBLESHOOTING OF DTC P0030
7
COMPLETED
Make sure to reconnect all
disconnected connectors.
Clear the DTC from the PCM memory
using the M-MDS.
(See
[13B-MSP].)
Perform the DRIVE MODE 3.
(See
MSP].)
Is the PENDING CODE same as the
DTC present?
VERIFY AFTER REPAIR PROCEDURE
8
Perform the "AFTER REPAIR
PROCEDURE".
(See
[13B-MSP].)
Are any DTCs present?
< Previous Next >
AFTER REPAIR PROCEDURE
OBD-II DRIVE MODE [13B-
AFTER REPAIR PROCEDURE
© 2011 Mazda North American Operations, U.S.A.
YesReplace the PCM, then go to the next step.
(See
PCM REMOVAL/INSTALLATION [13B-
MSP].)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See
DTC TABLE
No DTC troubleshooting completed.
[13B-MSP].)
Back to Top

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2011 rx-8

Table of Contents