Mazda RX-8 Workshop Manual page 671

CAUTION:
Diagnostic procedure
STEP
1 NOTE:
The following test should be
performed on the advanced
keyless entry and start
system. If not equipped, go
to the next step.
Start the engine using the mechanical ignition
key.
Does the engine start?
2 Do the following conditions appear?
The engine is not completely
started.
DTC P1260 is displayed.
3 Are the ignition coil connectors securely
connected to the coil?
4 Does the security light flash?
To prevent this, always complete "BEFORE SERVICE PRECAUTION" and
"AFTER SERVICE PRECAUTION" described in this manual. (See
SERVICE PRECAUTION
[13B-MSP].)
Disconnecting/connecting quick release connector without cleaning it may
possibly cause damage to fuel pipe and quick release connector. Always
clean quick release connector joint area before disconnecting/connecting,
and make sure that it is free of foreign material.
INSPECTION
[13B-MSP].) (See AFTER SERVICE PRECAUTION
RESULTS
Yes Inspect the advanced keyless entry and
start system and repair or replace according
to inspection result.
(See SYMPTOM TROUBLESHOOTING INDEX
[KEYLESS ENTRY
No Go to the next step.
Yes Both conditions appear:
Go to Step 5.
Either or other condition appears:
No
Go to the next step.
Yes Go to the next step.
No Connect the coil connectors securely.
Return to Step 1.
Yes Go to the next step.
No Inspect the instrument cluster and the
related wiring harness.
(See INSTRUMENT CLUSTER
BEFORE
ACTION
SYSTEM].)
INSPECTION.)