Mazda RX-8 Workshop Manual page 96

Inspect for continuity between the
following circuits:
Is there continuity?
VERIFY TROUBLESHOOTING OF DTC P0332
8
COMPLETED
Make sure to reconnect all disconnected
connectors.
Clear the DTC from the PCM memory using
the M-MDS.
(See
MSP].)
Perform the KOEO or KOER self test.
(See
Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
9
Perform the "AFTER REPAIR PROCEDURE".
(See
MSP].)
Are any DTCs present?
< Previous Next >
KS No.2 terminal A (wiring
harness-side) and PCM
terminal 2AC (wiring
harness-side)
KS No.2 terminal B (wiring
harness-side) and PCM
terminal 2Y (wiring
harness-side)
AFTER REPAIR PROCEDURE [13B-
KOEO/KOER SELF TEST
AFTER REPAIR PROCEDURE [13B-
© 2011 Mazda North American Operations, U.S.A.
YesReplace the PCM, then go to the next step.
No Go to the next step.
[13B-MSP].)
YesGo to the applicable DTC inspection.
No DTC troubleshooting completed.
(See PCM REMOVAL/INSTALLATION [13B-
MSP].)
(See DTC TABLE [13B-MSP].)
Back to Top