Mazda RX-8 Workshop Manual page 374

PERFORM PCM CONFIGURATION
3
Perform the PCM configuration.
(See
MSP].)
Clear the DTC from the PCM
memory using the M-MDS.
(See
[13B-MSP].)
Perform the KOEO or KOER self
test.
(See
[13B-MSP].)
Is the same DTC present?
VERIFY TROUBLESHOOTING OF DTC P0610
4
COMPLETED
Clear the DTC from the PCM
memory using the M-MDS.
(See
[13B-MSP].)
Perform the KOEO or KOER self
test.
(See
[13B-MSP].)
Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
5
Perform the "AFTER REPAIR
PROCEDURE".
(See
[13B-MSP].)
Are any DTCs present?
< Previous Next >
PCM CONFIGURATION [13B-
AFTER REPAIR PROCEDURE
KOEO/KOER SELF TEST
AFTER REPAIR PROCEDURE
KOEO/KOER SELF TEST
AFTER REPAIR PROCEDURE
© 2011 Mazda North American Operations, U.S.A.
YesPerform the PCM configuration again, then go
to the next step.
(See PCM CONFIGURATION
No Go to Step 5.
YesReplace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [13B-
MSP].)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE
No DTC troubleshooting completed.
[13B-MSP].)
[13B-MSP].)
Back to Top