Mazda RX-8 Workshop Manual page 546

INSPECT AIR SYSTEM OPERATION
7
Perform the Secondary Air Injection
(AIR) System Inspection.
(See ENGINE CONTROL SYSTEM
OPERATION INSPECTION [13B-
MSP].)
Does the AIR system operate
properly?
INSPECT FUEL LINE PRESSURE
8
Perform the "FUEL LINE PRESSURE
INSPECTION".
(See FUEL LINE PRESSURE
INSPECTION
Is there any malfunction?
INSPECT FUEL SYSTEM FOR FUEL LEAKAGE
9
Visually inspect fuel leakage in the
fuel system.
Is there fuel leakage?
INSPECT IGNITION COIL OPERATION AND
10 HIGH-TENSION LEAD WITH TIMING LIGHT
Inspect the blinking condition on
each high-tension lead using timing
light at idle.
Do all high-tension leads show
blinking condition?
INSPECT HIGH-TENSION LEAD OF NO
11
BLINKING HIGH-TENSION LEAD
Inspect the high-tension leads.
(See HIGH-TENSION LEAD
INSPECTION
Is there any malfunction?
INSPECT IGNITION COIL POWER CIRCUIT
12 FOR OPEN CIRCUIT OR SHORT TO GROUND
Turn the ignition switch to the ON
[13B-MSP].)
[13B-MSP].)
YesGo to the next step.
No Repair or replace the malfunctioning part
according to the inspection results, then go to
Step 21.
YesGo to the next step.
No Go to Step 10.
YesRepair or replace the malfunctioning part
according to the inspection results, then go to
Step 21.
No Replace the fuel pump unit, then go to Step
21.
(See FUEL PUMP UNIT
REMOVAL/INSTALLATION
YesGo to Step 14.
No Go to the next step.
YesReplace the malfunctioning high-tension lead,
then go to Step 21.
(See HIGH-TENSION LEAD
REMOVAL/INSTALLATION
No Go to the next step.
YesGo to the next step.
[13B-MSP].)
[13B-MSP].)