Mazda RX-8 Workshop Manual page 433

3 COMPLETED
Clear the DTC from the PCM
memory using the M-MDS.
(See
[13B-MSP].)
Start the engine.
Perform the DTC Reading
Procedure.
(See
TEST
Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
4
Perform the "AFTER REPAIR
PROCEDURE".
(See
[13B-MSP].)
Are any DTCs present?
< Previous Next >
AFTER REPAIR PROCEDURE
ON-BOARD DIAGNOSTIC
[13B-MSP].)
AFTER REPAIR PROCEDURE
© 2011 Mazda North American Operations, U.S.A.
YesReplace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [13B-
MSP].)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE
No DTC troubleshooting completed.
[13B-MSP].)
Back to Top