Mazda RX-8 Workshop Manual page 468

VERIFY TROUBLESHOOTING OF DTC P2196 COMPLETED
10
Make sure to reconnect all disconnected
connectors.
Clear the DTC from the PCM memory using the
M-MDS.
(See
Perform the DRIVE MODE 3 (A/F sensor
heater, HO2S heater, A/F sensor, HO2S, and
TWC Repair Verification Drive Mode).
(See
Is the PENDING CODE same as DTC present?
VERIFY AFTER REPAIR PROCEDURE
11
Perform the "AFTER REPAIR PROCEDURE".
(See
Are any DTCs present?
< Previous Next >
AFTER REPAIR PROCEDURE
OBD-II DRIVE MODE
AFTER REPAIR PROCEDURE
© 2011 Mazda North American Operations, U.S.A.
[13B-MSP].)
[13B-MSP].)
[13B-MSP].)
YesReplace the PCM, then go to the
next step.
(See PCM
REMOVAL/INSTALLATION [13B-
MSP].)
No Go to the next step.
YesGo to the applicable DTC
inspection.
(See DTC TABLE
No DTC troubleshooting completed.
[13B-MSP].)
Back to Top