Mazda RX-8 Workshop Manual page 226

Is there continuity?
VERIFY TROUBLESHOOTING OF DTC P0113
8 COMPLETED
Make sure to reconnect all
disconnected connectors.
Clear the DTC from the PCM memory
using the M-MDS.
(See
MSP].)
Perform the KOEO or KOER self test.
(See
MSP].)
Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
9
Perform the "AFTER REPAIR
PROCEDURE".
(See
MSP].)
Are any DTCs present?
< Previous Next >
terminal D (wiring
harness-side) and PCM
terminal 1AT (wiring
harness-side)
MAF/IAT sensor
terminal E (wiring
harness-side) and PCM
terminal 1AR (wiring
harness-side)
AFTER REPAIR PROCEDURE [13B-
KOEO/KOER SELF TEST [13B-
AFTER REPAIR PROCEDURE [13B-
© 2011 Mazda North American Operations, U.S.A.
YesReplace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [13B-
MSP].)
No Go to the next step.
YesGo to the applicable DTC inspection.
(See DTC TABLE [13B-MSP].)
No DTC troubleshooting completed.
Back to Top