Mazda RX-8 Workshop Manual page 291

recorded?
VERIFY RELATED REPAIR INFORMATION
2
AVAILABILITY
Verify related Service Bulletins and/or
on-line repair information availability.
Is any related repair information
available?
VERIFY RELATED PENDING CODE OR STORED
3
DTC
Turn the ignition switch off, then to the
ON position (engine off).
Verify the related PENDING CODE or
stored DTCs.
Are other DTCs present?
VERIFY CURRENT INPUT SIGNAL STATUS
4
Access the following PIDs using the M-
MDS:
(See ON-BOARD DIAGNOSTIC TEST
[13B-MSP].)
Are the PIDs normal?
(See PCM INSPECTION
VERIFY CURRENT INPUT SIGNAL STATUS UNDER
5 FREEZE FRAME DATA (MODE 2) CONDITION
CAUTION:
While performing this step with vehicle
driving, always operate the vehicle in a
safe and lawful manner.
When the M-MDS is used to observe
monitor system status while driving, be
sure to have another technician with
APP
ECT
MAF
TP REL
VSS
[13B-MSP].)
the next step.
YesPerform repair or diagnosis according to
the available repair information.
If the vehicle is not
repaired, go to the next
step.
No Go to the next step.
YesGo to the appropriate DTC inspection.
(See DTC TABLE
No Go to the next step.
YesGo to the next step.
No Repair or replace the malfunctioning part
according to the inspection results, then
go to Step 23.
YesGo to the next step.
No Repair or replace the malfunctioning part
according to the inspection results, then
go to Step 23.
[13B-MSP].)