Mazda RX-8 Workshop Manual page 846

2Engine mount bracket (RH)
3Engine mount rubber (LH)
4Engine mount bracket (LH)
5Engine, transmission
6Oil pipe, oil hose (AT)
(See OIL COOLER REMOVAL/INSTALLATION
7Oil hose
18. Install in the reverse order of removal.
19. Start the engine and inspect and adjust the following:
Pulley and belt for runout, tension, and contact
Leakage of engine oil, engine coolant, ATF, MT oil, and fuel
Ignition timing, idle speed, and idle mixture (CO and HC) (See
Front wheel alignment (See
Engine-driven accessories operation
20. Perform the on-road test and verify that there is no vibration or noise.
Oil Hose Removal Note
1. Remove the clip as shown in the figure and disconnect the oil hose.
CAUTION:
Catch the remaining engine oil in the oil cooler using a plate pipe to prevent spillage.
Power Plant Frame, Crossmember Bolt Removal/Installation Note
CAUTION:
The oil pan could be damaged or dented if the engine's own weight is subjected to an impact against a level surface. Always set two
pieces of wood in the positions shown in the figure to prevent the oil pan from being dented. If the oil pan is dented, the amount of
intake oil and the fluid pressure will decrease.
[SJ6A-EL].)
FRONT WHEEL ALIGNMENT.)
ENGINE TUNE-UP [13B-MSP].)