Mazda RX-8 Workshop Manual page 697

Start the engine and run it at
idle.
Measure the fuel line pressure at
idle.
Is the fuel line pressure correct
at idle?
(See FUEL LINE PRESSURE
INSPECTION [13B-MSP].)
37 Check the oil pipe between
metering oil pump and metering
oil nozzle.
Is there air and/or clogging in oil
pipe?
38 Verify test results.
If normal, return to the diagnostic index to service any additional symptoms.
If the malfunction remains, inspect the related Service Bulletins and/or On-line Repair
Information and perform repair or diagnosis.
*1
With advanced keyless entry and start system equipped module.
*2
Without advanced keyless entry and start system equipped module.
< Previous Next >
Yes
No
If the vehicle is repaired, troubleshooting is completed.
If the vehicle is not repaired or additional diagnostic information is
not available, reprogram the PCM if a later calibration is available.
Retest.
© 2011 Mazda North American Operations, U.S.A.
MSP].)
After that overhaul or replace the engine.
Inspect and repair for leakage and/or clogging in the oil
passage at the engine.
After that overhaul or replace the engine.
Overhaul or replace the engine.
Back to Top