Exporting Your Sequence To Tape - Matrox MXO2 Installation And User Manual

When you're ready to start the voice-over, click the Record button (
6
Click the Stop button (
7
added as an audio clip on the Timeline .
¦ Note During recording, your voice-over will not be output to your Matrox
MXO2 hardware, and audio punch-in monitoring is not supported.

Exporting your sequence to tape

You can record your sequence onto tape using device control or manually as
explained in your Avid documentation. Before exporting to tape, set your desired
playback settings as explained in
For a list of the supported video output formats, see
applications"
To export to tape without device control, simply play back your sequence and
record the output from any of the available outputs on your MXO2 system. If
your recorder supports RS-422 device control, you can connect the RS-422
connector on Matrox MXO2, MXO2 Rack, or MXO2 LE to the RS-422 serial
device control port on your recorder (see
page 18, "MXO2 Rack RS-422 serial connection"
RS-422 serial connection"
suitable adapter to connect the serial device control port on your source device or
recorder to your computer. For a list of supported device control adapters, see the
Matrox MXO2 Support section of our website at
www.matrox.com/video/support. When configuring your deck for RS-422 device
control, the RS-422 connector on your MXO2 hardware is usually identified as
the COM3 port.
To record the output from your MXO2 system using device control with the
Digital Cut
details on using the Digital Cut tool, see your Avid documentation.
¡ Important If you want to downconvert a 720p/23.976, 1080p/23.976, or
1080p24 sequence to SD to record a digital cut, you must change your project's
format (project type) to SD. For example, to downconvert a 720p/23.976 or
1080p/23.976 sequence to NTSC to record a digital cut, you must change the
project type to 23.976p NTSC. You can then select the output format that you
want in the Digital Cut tool.
) to stop the recording. Your voice-over will be
"Defining your playback settings"
on page 305.
on page 36). On Matrox MXO2 Mini, you must use a
tool, make sure that the Output Mode is set to Real-Time . For
"Playback using Avid editing
"MXO2 RS-422 serial connection"
on page 27, or
Exporting your sequence to tape
163
).
on page 144.
on
"MXO2 LE