Matrox MXO2 Installation And User Manual page 118

98
Make any required adjustment to the Mark In Time Code Offset in the
6
Matrox RS-422 Device Control Settings
export to tape with the same settings (In point at 00:00:10:00 and Out point
at 00:00:20:00.)
When the export to tape is finished, play back your tape and make sure that
7
your bars and tone clip stopped recording at 00:00:20:00 (the recording
should have started at 00:00:10:00). For example, if the recording stopped at
00:00:19:25 (five frames before your specified Out point), then you need to
set the Mark Out Time Code Offset to 5.
8 Once you've made any required adjustments to the Mark In and Out time
code offsets and ensured that your bars and tone clip starts and stops
recording at your specified In and Out points, perform another export to tape
with the In point for the recording set to 00:00:30:00.
When the export to tape is finished, go to 00:00:30:00 on your tape, and
9
check which frame from your sequence has been recorded. You should see
frame 00:00:00:00 from your bars and tone clip at 00:00:30:00 on your tape,
with no repeated frames. For example, if frame 00:00:00:00 has been
repeated for the next five frames, then your sequence started playing back
five frames too early and you need to set the Playback Offset to 5.
Alternately, if you see frame 00:00:00:05 from your bars and tone clip
recorded at 00:00:30:00, then the sequence playback started five frames too
late and you need to set the Playback Offset to -5.
Chapter 8, Using Matrox MXO2 with Adobe Premiere Pro
dialog box, and perform another