Matrox MXO2 Installation And User Manual page 171

YUV/RGB
$
type of video signal that is sent from the component output. For example,
select RGB - native if you connected the component output to a device
that accepts an RGB signal.
YUV/RGB
$
want to be sent from the HDMI output:
Outputs YUV HDMI video. Select this only if you connected
YUV
•
the HDMI output to a device that accepts a YUV signal.
RGB - calibrated
•
currently loaded Matrox HDMI calibration settings for your HDMI
monitor or television. For details on calibrating your HDMI monitor
and loading calibration settings using the Matrox HDMI Calibration
Utility, see
RGB - native
•
any calibration compensation. This is useful when you want to output
RGB HDMI video to a device other than an HDMI monitor or
television, such as an HDMI recorder to perform an export to tape.
3D Viewing Mode
$
from the HDMI output to your 3D monitor (this feature may not be
supported on some 3D monitors):
Disabled
•
3D video output. You can still monitor 3D video, but you must select
the correct viewing mode on your 3D monitor manually.
Side-by-side
•
video (also referred to as side-by-side horizontal).
Over/Under
•
bottom).
¡ Important If your project's Stereoscopic setting is anything other than
Side by side
to Disabled . For example, if your project's Stereoscopic setting is
Mode
Off or Leading Eye , you must disable the 3D video output in order to
properly view the HDMI output.
Under Advanced , select Allow Super White to allow the highest
5
luminance level of your video output to exceed the standard maximum white
level. Select Allow Super Black to allow the lowest luminance level of your
video output to fall below the standard black level. These options apply to
both the main analog output and secondary HDMI output.
¦ Note
Super white and super black should not be allowed when producing
your final video production for broadcast.
Click OK to save your settings.
6
(for analog output) Select YUV or RGB - native to set the
(for HDMI output) Select the type of video signal that you
Outputs adjusted RGB HDMI video using the
Chapter 7, "Calibrating Your HDMI Monitor for
Outputs native RGB HDMI video that does not apply
Select the 3D signal type that you want to be sent
Select this if you're not outputting 3D video, or to disable
Outputs horizontally compressed side-by-side 3D
Outputs over/under 3D video (also referred to as top
, Over/Under , or Full , make sure that you set the 3D Viewing
Defining your playback settings
151
Video."