Exporting Your Sequence To Tape; Avoiding Issues When Using Matrox Device Control; Exporting To Tape Using Matrox Device Control - Matrox MXO2 Installation And User Manual

94

Exporting your sequence to tape

To export your Adobe Premiere Pro sequence to tape without using device
control, simply play back your sequence and record the output from any of the
available outputs on your MXO2 system. If your recorder supports RS-422
device control, you can export your sequence to tape using Matrox device control
as explained in
Avoiding issues when using Matrox device
control
Keep the following points in mind when exporting to tape using Matrox device
control:
• To avoid having discontinuous (broken) time code recorded onto your tape
when using Matrox device control, set your recorder to generate time code
internally based on time code already present on the tape (this setting is
called INT REGEN on some devices). Don't use free run or external time
code regeneration mode.
• Because Matrox device control requires a preroll, don't start the export to
tape within the first ten seconds on your tape or at a time code less than
00:00:10:00.
• To avoid repeated frames or broken time code when performing an assemble
edit using Matrox device control, add ten seconds or more of black video or
color bars to the end of your sequence.

Exporting to tape using Matrox device control

With Matrox device control, you can perform either an insert or assemble edit to
record your Adobe Premiere Pro sequence onto tape as follows:
Open your project, activate the sequence that you want to export to tape, and
1
position the work area bar over the section of the sequence that you want to
export.
If you haven't already done so, render all sections that are identified with a
2
red or yellow render bar.
¦ Note
render bar when you start an export to tape, but to avoid having dropped frames
you must render both the red and yellow sections before performing a Matrox
export to tape.
Make sure that you've properly connected your RS-422 recorder and
3
configured Matrox device control as explained in
control"
Load a striped recordable tape into your recorder, and set your recorder to
4
Remote or VTR mode.
Chapter 8, Using Matrox MXO2 with Adobe Premiere Pro
"Exporting to tape using Matrox device control"
Adobe Premiere Pro will automatically render sections that have a red
on page 90.
on page 94."
"Setting up Matrox device