Polaroid ID-3000 Repair Manual page 94

Polaroid ID3000 Service Manual
PCS_PIXELFORMAT - Selects the method the CS500 controller uses to store image
CHUNK =
LINE =
PLANE =
Default: PLANE
PCS_AOIX1
PCS_AOIX2
PCS_AOIY1
PCS_AOIY2 - The PCS_AOIxn values define an "Area of Interest" which is the
PCS_DATANAME - The name of the film color lookup table downloaded to the scanner,
PCS_HARDBUF -
PCSWINDOW -
PCS -
data in memory. Possible values:
send the data in continuous format of red, green
and blue data bytes.
send scan line's worth of red pixels followed by
scan line of green and<+!><-!> then a scan line of blue.
send an entire plane of red image data followed
by an entire plane of green and then a plane of blue.
area of the image to be scanned. These values define a rectangle
with X1,Y1 being the upper left of the rectangle and X2,Y2 being
the lower right. The units specified for these parameters are in DPI
for the resolution selected. Default values:
X1 = 080
Y1 = 080
X2 = Maxwidth for 125 DPI
Y2 = Maxheight for 125 DPI
X2-X1 is the width of the image to be scanned in DPI
Y2-Y1 is the height of the image to be scannedin DPI
for color balancing the scannedimages based on the film type. The
default table is PCSDFLT.DAT, which is for 35mm film and is also
acceptable for Spectra film.
The internal size of the PCS hardware buffer. Older models of the
scanner have smaller buffers than the newer "FIFO" (CS-500i)
models of the scanner. Possible values:
2MEG - 2 Megabyte "FIFO" (CS-500i) scanner.
0MEG - Older 64K model of the scanner.
Default value:
2MEG
This variable enables and disables a menu display when the
controller is activated for scanning. Possible values:
OFF - Bypass menu, scan immediately
ON - Display the menu
This variable enables or disables the entire PCS controller.With this
value set to "OFF" the controller behaves as if it did not exist. This
3-12
Troubleshooting/Diagnostics