Polaroid ID-3000 Repair Manual page 203

Polaroid ID3000 Service Manual
Replacing the TX-1500 Color Thermal Printer & Power Supply Assembly
1. Unpack the new TX-1500 Printer and save all packing materials to use in returning the old
printer.
2. Unplug all cables from the rear of the Printer.
3. While supporting the Camera Post, remove the two thumbscrews holding the Post to the
Printer (Figure 5-4). Put the Post, Camera and Strobe in a safe, protected place.
Figure 5-4 Removing thumbscrews from Camera Post
3. Remove the five screws "C" holding the Housing Component to the Chassis Adapter (two
from the top, three from the bottom —see Figure 5-5). Lift off the Housing Component.
4. Unplug the three cables "D" from the rear of the Printer.
5. Cut the tie wraps securing the power cable "E". Disconnect the black and white wires
from the terminal strip and the ground wire from its chassis tie point.
NOTE: Be sure DIP switches A & B are all set correctly. For
interlaced or non-interlaced input, refer to Appendix 2.
Figure 5-5 Removing Power Supply chassis assembly
5-5
Parts Replacement